Difference between revisions of "Cable"

From The University of Akron Support Wiki
Jump to: navigation, search
(Created page with "==Setting up On-Campus Cable== <br>When setting up on-campus cable within student living spaces perform the following steps:<br><br> 1) Connect a coaxial cable from the TV wal...")
 
Line 1: Line 1:
 
==Setting up On-Campus Cable==
 
==Setting up On-Campus Cable==
 +
 
<br>When setting up on-campus cable within student living spaces perform the following steps:<br><br>
 
<br>When setting up on-campus cable within student living spaces perform the following steps:<br><br>
 +
 
1) Connect a coaxial cable from the TV wall outlet to the input port on the
 
1) Connect a coaxial cable from the TV wall outlet to the input port on the
 
back of your TV.<br>
 
back of your TV.<br>
 +
 
2) Connect the TV power cord to the wall electrical outlet and turn on the TV.<br>
 
2) Connect the TV power cord to the wall electrical outlet and turn on the TV.<br>
 +
 
3) Using your TV remote, select Menu and then select and run the Auto-Setup feature.<br><br>
 
3) Using your TV remote, select Menu and then select and run the Auto-Setup feature.<br><br>
<big><b>At this point your TV is now ready to RECIEVE the cable signal.</b></big><br><br>
+
 
 +
{{yellowbox|Please note:|At this point your TV is now ready to RECIEVE the cable signal.}}<br><br>
 +
 
 
4) Next you now need to scan and store your channels. This process stores the channels into your television’s memory, and deletes from memory any unused or inactive channels. In general there is an option listed as AUTO PROGRAM<br><br>
 
4) Next you now need to scan and store your channels. This process stores the channels into your television’s memory, and deletes from memory any unused or inactive channels. In general there is an option listed as AUTO PROGRAM<br><br>
  
{{yellowbox|Please note:|AUTO PROGRAM is usually a menu selection on the same menu where you selected CABLE. There may be a button on your remote which says AUTO PROGRAM, CHANNEL SCAN, AUTO SCAN, or something similar.}}
+
{{yellowbox|Please note:|AUTO PROGRAM is usually a menu selection on the same menu where you selected CABLE. There may be a button on your remote which says AUTO PROGRAM, CHANNEL SCAN, AUTO SCAN, or something similar.}}<br><br>
 +
 
 +
5) Once you have selected or pressed AUTO PROGRAM, your screen may go blank or turn blue, then will begin cycling through all of the cable channels. DO NOT interrupt the scan (otherwise you may have to scan all over again).<br>

Revision as of 15:07, 13 August 2019

Setting up On-Campus Cable


When setting up on-campus cable within student living spaces perform the following steps:

1) Connect a coaxial cable from the TV wall outlet to the input port on the back of your TV.

2) Connect the TV power cord to the wall electrical outlet and turn on the TV.

3) Using your TV remote, select Menu and then select and run the Auto-Setup feature.

Content.png Please note:
At this point your TV is now ready to RECIEVE the cable signal.


4) Next you now need to scan and store your channels. This process stores the channels into your television’s memory, and deletes from memory any unused or inactive channels. In general there is an option listed as AUTO PROGRAM

Content.png Please note:
AUTO PROGRAM is usually a menu selection on the same menu where you selected CABLE. There may be a button on your remote which says AUTO PROGRAM, CHANNEL SCAN, AUTO SCAN, or something similar.


5) Once you have selected or pressed AUTO PROGRAM, your screen may go blank or turn blue, then will begin cycling through all of the cable channels. DO NOT interrupt the scan (otherwise you may have to scan all over again).